Knowledge base
How to: Configure a ByteBlower 1100 server to boot from USB
Posted by Vincent De Maertelaere, Last modified by Dries Decock on 03 April 2018 01:55 PM

Introduction

For some procedures the ByteBlower server must boot from an USB-key.  This how to describes how to configure the BIOS to boot from an USB-key.

WARNING:  It is important that the configuration is reverted when e.g. the installation is done.  Otherwise the server may not boot consistently.

Procedure

  1. Connect a screen and keyboard to the server.

  2. Power on the server.

  3. When following screen is shown, press the F2-key to enter the BIOS setup.


  4. Use the up and down arrows to select USB Flash Drive Emulation Type


  5. Use the + and - keys to select "Hard disk"


  6. Press escape and select Save Changes and Exit.  Use RETURN to confirm.



  7. At reboot press the F2-key to enter the BIOS setup again.



  8. Use the up and down arrows to select Hard-Disk Drive Sequence


  9. Use the +,- keys to move the "Hard-disk-emulated USB flash drive" as the first device


  10. Press escape to get to the Save Changes and Exit menu.  Confirm using RETURN.


(0 vote(s))
Helpful
Not helpful

Comments (0)

We to help you!