Wireless Endpoint 1.1
Posted by Tom Ghyselinck, Last modified by Craig Godbold on 18 August 2023 03:09 PM

You can find the detailed installation instructions in our How to: Install the Wireless Endpoint on your device.


You can find the downloads at following location: https://setup.byteblower.com/wirelessendpoints.html

Changelog 1.1.28 (2019-04-03)

  • Fix issue with huge result-sets being communicated to the meetingpoint
  • Threads where created on the windows version and never destructed. This has been resolved
  • Abort button didn't work anymore under certain conditions. This is resolved and you now can abort again the app

Changelog 1.1.26 (2019-03-05)

  • Improvement on the core implementation. Prepared the code for TCP restart.
  • Improved heartbeat protocol. Where in previous versions, it could be so that your app stayed in contacting while there was WiFi or visa versa. This is now fixed and the app will handle much better the change between connected and disconnected.

Changelog 1.1.22 (2018-10-09)

Changelog 1.1.20 (2018-07-11)

  • Fix communication of all known networkinterfaces of Windows Wireless Endpoint to ByteBlower ( Invalid JSON format )

Changelog 1.1.18 (2018-06-01)

  • Some devices hanged when wifi-connection is lost. This has been resolved
  • Symantec blocked the TCP testing-traffic. TCP payload now is more realistic and symantic doesn't block the traffic anymore

Changelog 1.1.12 (2018-02-20)

  • Improve stability when channelhopping. Traffic was previously dropped
  • IPv6 UDP flows: Total transmitted/recieved bytes was incorrect. The calculation of the IP-header was wrong
  • Improving the re-connection. Sometimes The Wireless endpoint didn't reconnect when WiFi signal was lost.

Changelog 1.1.6 (2017-09-22)

  • Improve timings
  • Bugfixing

Changelog 1.1.4 (2017-05-30)

  • Improve stability of long tests

Changelog 1.1.2 (2017-04-12)

  • UDP upstream bugfix
  • Fix link to this Changelog

Changelog 1.1.0 (2017-04-06)

  • Improvements in UX and UI
    • Gauge for Tx
    • Gauge for Rx
    • Added device info
    • Added Network info containing the device interfaces and there IP's
    • Improved design for tablets
    • Added landscape mode
  • Added support for IPv6 traffic
  • Added support for latency measurements
  • Added support for bi-directional traffic
(0 vote(s))
Not helpful

Comments (0)

We to help you!