Running the test with an Endpoint
| Running the test | Up to this point, there has been no real communication or connection with the ByteBlower server. Once we run the test, the server comes into the picture.
When we run the test, the wireless device will stop communicating with the server. The test that we have created sends instructions to the device regarding the test protocols. Once the test is completed, the device will begin communicating again with the server which will obtain the results stored on the device under test. This is then relayed to the GUI on your computer.
|
| Looking at the report | When the test has finished, the report should be opened either in the GUI or in a separate browser:
This is an example report:
|
